ESS6008MSK | 12V 60/70A | 270A Boost | Smart Charger/Analyzer & Power Supply

Description

Associated Equipment 12 Volt 60/70 Amp & 270 Amp Boost | Smart Charger & Power Supply
The Associated Equipment ESS6008MSK is the complete package for the professional shop. When technicians are hunting down drivability intermittent problems that are often caused by poor grounds, the technician will often put the key in the "KEY ON /ENGINE OFF Mode" and go under the hood with their Multi-meter or Scope and check for bad grounds. With the electrical draw on today’s batteries every ground he checks gets a different voltage reading making it difficult to distinguish good grounds from bad.
Several of the Associated Intellamatic® Smart Chargers in addition to charging and performing diagnostics on batteries, or performing deep discharge recovery or rejuvenation also has a power supply that can deliver a clean 13.9 volts depending upon model up to 70 Amps. This will provide the clean power needed (13.9V) to allow the vehicle’s battery and electrical system to stay above the minimum voltage required for re-flashing or give the technician a stable reference voltage to check for bad grounds.
Anytime a scan tool is hooked to a vehicle it’s always a good idea to have a power supply hooked up. If battery voltage drops too low during scan tool diagnostic "off false" codes are set in.
FEATURES
Electrical Stability System (ESS) technology turns the ESS6008MSK into a 70A stable power supply for extended service procedures or re-flashes. Nominal 13.7 volt DC Output.
Memory Saver Mode 15-Amp Continuous / 20-Amp Peak
Program for deep discharge recovery of flooded batteries.
Patented diagnostics indicate weak or defective batteries.
Designed for AGM, Gel Cell, Sealed, and Standard Flooded batteries including Spiral Cell, Orbital, or Optima batteries.
Dead Battery Override control
5-Amp 12-Foot Straight Cable with OBDII Connector - Male Cigarette Plug.
Terminal Covers to prevent positive battery clamp from arcing (pair).
Made in the USA
SPECIFICATIONS
DC Output (
Power Supply Mode
) :
60/70 Amps
DC Output (
Continuous
) :
15 Amps
DC Output (
Memory Saver Port
) :
20 Amp Peak
DC Leads :
6.5 Feet | 4 Gauge
Clamp Rating :
400 Amps
Weight :
50 Pounds
AC Cord / Voltage :
6-Foot 16-3 | 120VAC 60 Hz
Memory Saver Cord :
5 Amp (Straight) | 12-Foot | OBDII Connector
Battery Terminal Covers :
Red Pair | Associated
Display :
Analog Meter and 3-LED display (Indicates Charge Status)
BATTERY TYPES
12-Volt Flooded
AGM
Gel Cell : Including Spiral Cell, Orbital, and Optima Batteries